search:beaglebone gpio相關網頁資料
-
-
![Beaglebone: GPIO Programming on ARM Embedded Linux - YouTube]()
www.youtube.comNote: This video was made before the Linux device tree was implemented on the beaglebone (beaglebone black uses Linux 3.8.11). I have a new video coming in a few days that explains how to do the same thing on the beaglebone black using device tree overlay瀏覽：709 -
![GPIO tutorial for the BeagleBone Black (Shallow Thoughts)]()
shallowsky.comGPIO tutorial for the BeagleBone Black Want to get started controlling hardware from your BeagleBone Black? I've found a lot of the documentation and tutorials a little sketchy, so here's what I hope is a quick start guide. I used the Adafruit Python GPIO瀏覽：1469
beaglebone gpio的相關文章
beaglebone gpio的相關公司資訊
beaglebone gpio的相關商品
瀏覽：1402
日期：2025-04-29
Hi, I’m trying to recompile BeagleBone White kernel sources using the new version 3.8 so i can configure GPIO’s and UART’s and when i do it my board can’t boot anymore. The steps i’m doing is: dtc -O dtb -o am335x-bone.dtb -b 0 -@ am335x-bone.dts Copy and...
瀏覽：400
日期：2025-04-23
New Version for newer versions of Linux (3.8.x) In this video I am going to continue my series on the Beaglebone by demonstrating how to use its GPIOs for both input and output applications. In this video I will wire simple input and output circuits that ...
瀏覽：803
日期：2025-04-27
To control digital input / outputs for the BeagleBone Black, you can use the facilities exposed by the kernel in the /sys/class/gpio directory. Note that the BeagleBone White pinouts are different from the BeagleBone Black. Also note that the GPIOs availa...
瀏覽：558
日期：2025-04-23
Thank you so much for the great article! Question, I am able to get P8_3 working as you describe in the tutorial, but I cannot seem to get the GPIO to work on any other pins. For gpmc_ad6 it shows gpio1_6 which matches the BeagleBone manual. For P8_4 ......
瀏覽：1480
日期：2025-04-23
In this video I continue my series on the Beaglebone and Beaglebone Black by demonstrating how to use its GPIOs for both input and output applications. I wire simple input and output circuits that are attached to two GPIOs -- one that lights an LED and th...
瀏覽：529
日期：2025-04-27
This post describes how to use the GPIOs on the Beaglebone Black using Device Tree Overlays. It demonstrates how to connect an LED and how to connect a push ... This post provides supplementary information to the video that I have just posted on using ......
瀏覽：1254
日期：2025-04-28
Now that we know the pin is configured as an output, it’s time to get blinking. We could use the GPIO_DATAOUT register to do this, but we would want to preserve the state of all the other bits in it, so we would need to do the same process of unpacking .....
瀏覽：762
日期：2025-04-27
NB. P6 is not available on BeagleBone Black IMPORTANT This diagram of P6 provides an UNDERSIDE PINOUT view. It is therefore laterally inverted relative to the photograph. To obtain the top-side pinout that corresponds to the physical orientation shown in ...
網友正在看
熱門 gtc 文章
